Eutalloy 10185

Eutalloy 10185

Self-flowing metal powder based on NiBSi. High wear resistance against adhesion even at high temperatures. Low coefficient of friction with metallic sliding friction. Corrosion resistant. Withstands impact stress. Smooth coatings, not susceptible to cracking. Can be machined.

Technical data
Hardness [HV 30]: 390*
DIN EN 1274: ~ 2.3 - 125/20 - atomized
Grain size distribution [μm]: 20 - 125
Melting interval (Sol./Liq.) [°C]: 1050 - 1175
Working temperature [°C]: 1100
Density [g/cm³]: 7.9

Applications
For thermal spraying with simultaneous melting of unalloyed, low-alloy and high-alloy steels and the corresponding cast steel grades as well as cast iron materials and nickel alloys.

Typical application examples are
Moulding tools in the glass industry, tools and dies in the plastics industry, bearing seats, shafts, cams, casting moulds and eccentrics.

Processing instructions
Remove damaged material. Clean spray areas. When spraying, adjust the heat to the component, its material and dimensions. To protect the surface against oxidation, spray on a thin layer and melt in while adding more powder. Allow to cool in still air.

Spraying device: SuperJet Eutalloy S
Preheating: GJL: 600 - 800 °C
Steel: 300 - 400 °C

*The achievable hardness values depend on the selected spraying parameters, preheating temperatures, etc. No guarantee can therefore be given that the hardness values will be achieved.